Español| Home | Our Story | Distributors | News | Contact Us |

| Catalog | Manual | Features | Designation | Warranty | Calculator

Introduction

Strength

Electrical Power

Electrical Communication

Temperature Rating

Special Cable Problems

Cable Service

Reversing a Line

Attenuation VS Freq
Graph

Electrical Fault
Location

Derivation of Fault
Detection Formula

Manual Menu

Cased Hole

REVERSING A LINE

There is often a desire to reverse a line or turn it end for end so that the virgin portion of the line can be used. This practice is not recommended for the following reasons:

1. Problems of overlap of new tension-rotation profile with previous tension-rotation profile can result in loose armor or high wires.

2. "Z - kink" formation when the tension is lowered from operational tensions to shipping reel spooling tensions.

3. Corrosion rate accelerated due to used portion of cable not being flexed.

4. Cable weak point no longer guaranteed to be at the cable-head.

5. Potential problems with spooling due to smaller diameter of used section of line.
   

Previous Page | Print Page