Español| Home | Our Story | Distributors | News | Contact Us |

| Catalog | Manual | Features | Designation | Warranty | Calculator

Introduction

Terms
Specifications

Cable
Construction

Portable Marking
Unit

Stationary Drum
1 Capstan

Stationary Drum
2 Capstan

Steps to Good
Cable Care

Calculating
Pull-Out Point

Rehead Strenght
Calculations

Specific Gravity
Weight and Pressure
Table

Calculating
Stuck Point

When Tool or
Cable is Stuck

Steps to Find
Stuck Point

Eliminating Errors

Things to check

Back to Manual Menu

CABLE CARE

To help eliminate possible errors:

1. Write down all depths, tension and stretch measurements.

2. Always have at least two people do the calculations and make sure they agree.

3. After pulling additional 1000 lbs. and measuring stretch, slack off and start over at step one again.

4. Check depths, tension and stretch measurements and slack off and start over at step one again.

5. Watch for any tool movement.

6. Make sure rig blocks do not move.

7. Make sure wireline sheaves are secure.

8. Make sure Truck/Skid does not move.

Previous Page | Print Page